71-72 OEM Charcoal Canister Bracket
#1
71-72 OEM Charcoal Canister Bracket
71-72 charcoal canister bracket Cutlass, 442, H/O.
These are hard to find with no rust holes.
This one is in very nice shape with no rust holes. Had slight pitting on inside but exterior is extremely clean. Has original clamp screw. Was bead blasted and finished in GM resto black.
SOLD...
$75 plus shipping from 32828.
These are hard to find with no rust holes.
This one is in very nice shape with no rust holes. Had slight pitting on inside but exterior is extremely clean. Has original clamp screw. Was bead blasted and finished in GM resto black.
SOLD...
$75 plus shipping from 32828.
Last edited by rickw30; May 9th, 2024 at 02:40 AM.
#15
Rick, I would like to get this from ya, but as mine sits, it won’t fit due to the dealer installed radiator overflow tank bracket. I have to figure something out to be able to do this with minimal violence to that area.
#16
#17
Yes, it is actually setup to siphon back into the rad. I have a siphon tube immersed in coolant in the tank. The cap is a wiper fluid cap with a tube that is cut to length to reach the bottom of the tank.
#20
I think I may be able to move the overflow tank bracket a little away from the center of the hole that the canister sits and make just enough room for the bracket. If I could get a measurement from the center of the canister mount out to the edge of it, I could make a measurement here to see if I have enough room.
Thread
Thread Starter
Forum
Replies
Last Post
11971four4two
Parts For Sale
5
August 11th, 2020 01:45 PM