Parting 72 Cutlass supreme
#41
#42
#45
Hi I am in Lindstrom , Probably a little over an hour from you. Try and get me a list , it would be cheaper to ship probably with the cost of gas. I build homes sometimes in Maple Grove but none now. Let me know.
#48
Just got the fender trim yesterday.
They were so nice looking, the rest of my surrounding trim looked like crap.
So out came the metal polish…
After a finger and hand-numbing massage on the rest of my trim, it all looked great together!
Many thanks!!
They were so nice looking, the rest of my surrounding trim looked like crap.
So out came the metal polish…
After a finger and hand-numbing massage on the rest of my trim, it all looked great together!
Many thanks!!
#53
#55
The sockets are made of copper and clean up with some patience. But they need a complete new wire setup. The fire or major heat from exhaust melted the wires.also the backs need a wire wheel taken to them , front insides are clean and no damage to mounts. I have a tip for you though , the wires in these tail lights push through the socket towards the bulb. I have pushed them up a few inches on mine and you can clean out all the grease and gunk from the spring and socket , Usually the problem with these lights is that the spring does not pop back up when you put a bulb in. You can also go from under neath and push up on your wires and it will tighten up the spring and contacts to your bulb.
40 shipped for the housings , they are getting pretty hard to find.
40 shipped for the housings , they are getting pretty hard to find.
#65
I have an oil pan , but you would need to give me time to pull it. I just got a 1970 Trans am and I am kind of excited so am putting time into running numbers on it.
#66
#68
I have good housings but the wires are toast from heat or fire. Try pushing your wires through from the back side and clean out the socket and shoot some wd40 in there and work the spring .shoot wd40 on the rubber casing around the wires on the back to and the wires will slide right through.
If you want the housings let me know , I think I have a pic in this thread previously.
#72
#77
BUMPER JACK POR 15 FINISHED WITH ALL PARTS EXCEPT TIRE IRON 100.00
Do you still have this? Any pics of it? This is the correct jack for the car right?
Do you still have this? Any pics of it? This is the correct jack for the car right?
#78
here is a couple pics , it is dusty.
The base has a U on the front
The stand has Patent # 6163925
The hook has # 411611
the mechanismm says "Oil me after use"
It actually works great.
And
The base has a U on the front
The stand has Patent # 6163925
The hook has # 411611
the mechanismm says "Oil me after use"
It actually works great.
And